12/18/2023 0 Comments Add server to emby serverIf you want to get files in and out of the container, Volumes and Bind points are necessary. (This is something I wrestled with when learning to configure Dockers.) Movies>Movies not Movies>movies otherwise (if now Linux) this will not work.ĭockers are designed to isolate the container from the host. So by doing this you are creating a symlink to the folder outside of the container, is that necessary? why not just map the data volume.One of the options in Emby is the 'cache path' which holds the cache, metadata and transcode temp folder.Īlso by adding the host path and container path they will have to be the same, i.e. BTW: you could do an OMV version upgrade to 4.0 with an extra stick as well, just to see how it goes. (Dockers have all dependencies built in.)Īgain, you can test this with a cloned boot stick with no consequence. I don't think an Emby/Docker build will care about whether OMV 3 or 4 is in use. (I have to say, it looks good enough to where I'm considering adopting it.) If all is well, I suppose I could write up a How-To. Since you know far more than I do about the function of Emby server, let me know how it works for you. For copy and paste purposes put the following in Extra args: Repeat the process as needed for /Videos, /Movies, etc. Remember, you have to click on the check box and see a new blank line, to insure the Bind point has been accepted. Use the folder icon (highlighted yellow), to navigate to your data drive and set it your music share. As you create the locations /music on the inside of the container maps to a location on the outside of the container (on the left side below - Host Path). You'll find these folders, created on the container path side, inside of Emby when you set up media locations. You probably have more folders than the two shown. The second and third lines, /music and / videos folders, under Container path, are examples. The left side (at the root of the boot drive) can be anything but avoid selecting an existing location. The first Host Path stores the Emby config so that your settings are persistent. For copy and paste purposes, for the device in Environment Variables: The UID and GID are numbered so as not to conflict with existing Dockers. The following is 2 screen captures for filling in the run image dialog. Even if it won't, much like Pi-hole, the configuration is on the host so it should be persistent even if a new image is installed.įirst you want to "pull image" with the following: While I don't know for sure, I believe this container will update in place. The image following is the official (supported) Emby Docker image for 圆4 hardware. Remember, Dockers are a non-invasive way to add a server function so if the following doesn't work, delete it. If you're interested, you could backup your USB boot stick and give the following a try.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |